Procedure

The following stages listed are the steps that we went through in order to create our final version of our pop filter.

We used a knife to cut out the inside of the strainer in order to create the frame.
After cutting out the inside of the strainer, there were some sharp spikes from the material that were still attached to the inside of the frame. We felt that this could possibly rip the pantyhose, so in order to ensure that it does not rip them we attached a layer of duct tape around the whole frame.
Next, we cut the pantyhose so that all that was left was the leg. We then pulled the pantyhose over the frame to cover it. After doing this, we realized that there was too much extra material, so we tried to cut it. However, this ended up distorting the pantyhose, and it also ended up not covering the full frame once cut.
To solve this issue, we had to start over with a new pair of pantyhose. We then slid the pantyhose over the frame again, and cut the extra bits off, leaving a bit of material left that we then tied with hair elastics to secure it.
The last step was to attach the toilet paper holder to the frame that we had created.To do this, we placed them side by side and taped them together with duct tape.